Audio Control EQL Owner's Manual download pdf (Page 18)

Appendix B

Final Setup for the EQX

The initial part of the setup for the EQX is covered in the previous section.

1. Set the HIGH FREQUENCY and LOW FREQUENCY output controls of the EQX to 12

o’clock. Advance the head unit’s volume control toward 75%. If the amplifiers clip, or if the

system gets too loud, you are done. If you reach 75% without the amplifiers reaching clipping,

or if the system isn’t loud enough (and the amplifiers aren’t clipping), increase the setting of the

LOW FREQUENCY output control until the system is too loud, or you reach amplifier clip-

ping, whichever happens first. Now readjust the high frequency output controls for a pleasing

balance between the two parts (high and low, not left and right) using a variety of sources. If the

sensitivities of your components are somewhat out of the ordinary (like tweeters less sensitive

than woofers), then you may need to adjust the HIGH FREQUENCY output control instead. At

least one of the two controls (per channel) should be set at or near 12 o’clock.

2. Now that you have established the high/low balance for your system and matched the input and

output levels, press the IN/OUT button on the EQX to enable the equalizer section. Now you

can begin the equalization process.

Appendix B

1 2 ... 13 14 15 16 17 18 19 20

No comments

Audio Control EQL Owner's Manual Page 18